Changes to Step #14

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Assemble cable guide back
[* 5] Screw ''cable_guide_back_a'' and ''cable_guide_back_b'' to the ''x_carriage'' using an M3x40 screw
-[* 7] Zip-tie the heater and thermistor to the bottom of the ''cable_guideback_b''
+[* 9] The M3x40 screw should be at a slight angle to the horizontal while you are tightening it.
+[* 7] The M3x40 screw should be at a slight angle to the horizontal while you are tightening it.
[* 1] Add the textile sleeve as explained in the Prusa manual for MK3S (steps 62 to 64): https://manual.prusa3d.com/Guide/5.+E-axis+assembly/1055?lang=en#s18603