Changes to Step #10
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Assemble X Carriage |
|---|---|
| [* 7] Secure the Pinda on the ''pinda_mount'' with an M3x10 screw. The Pinda should be out in the bottom by approx. 10mm | |
| [* 2] Route the stepper motor, nozzle fan and Pinda as shown in the second image. Make sure to not pinch any wires | |
| [* 5] Attach the ''x_carriage'' on the ''body_back'' with two M3x18 screws | |
| [* 4] And one M3x10 | |
| [* 9] Double check you didn't pinch any wires. You should be able to slide them a little if you push/pull on them. |