Changes to Step #10

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Assemble X carriage
-[* 7] Secure the Pinda on the ''pinda_mount'' with an M3x10 screw. The Pinda should be out in the bottom by approx. 10mm
-[* 2] Route the stepper motor, nozzle fan and Pinda as shown in the second image. Make sure to not pinch any wires
+[* 7] Secure the Pinda on the ''pinda_mount'' with an M3x10 screw. The PINDA should be out in the bottom by approx. 10mm
+[* 2] Route the stepper motor, nozzle fan and PINDA as shown in the second image. Make sure to not pinch any wires
[* 5] Attach the ''x_carriage'' on the ''body_back'' with two M3x18 screws
[* 4] And one M3x10
[* 9] Double check you didn't pinch any wires. You should be able to slide them a little if you push/pull on them.