Changes to this Step
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Hot tightening the Hemera nozzle |
|---|---|
| + | [* 1] Hot tighten the Hemera nozzle to 3Nm at 285°C. Follow the official instructions from E3D here (step 18): [https://e3d-online.dozuki.com/Guide/02+-++E3D+Hemera+Direct+Assembly/127?lang=en#s1639] |