Changes to this Step

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

+[title] PINDA probe height adjustment
+[* 1] Let the extruder cool down.
+[* 1] Place a sheet of paper on the heated bed. Manually lower the X axis until the Hemera nozzle is touching the paper.
+[* 1] Make sure the X axis is flat (you can slowly move the Hemera left and right).
+[* 1] Loosen the PINDA locking screw and place an object of 1mm thickness under the Pinda (like the middle section of a zip tie).
+[* 1] Gently move the PINDA down until it is touching the zip tie.
+[* 1] Tighten the PINDA locking screw to secure it in place.
+[* 10] Use a plier if it is hard to reach the probe with your fingers during adjustment.