Changes to Step #1
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Prepare SD card |
|---|---|
| + | [* 9] These instructions are only needed because no custom firmware is available yet. |
| + | [* 1] Copy the following files to your SD card |
| + | [* 1] ``bear_hemera_config_mk*.gcode`` (choose the version corresponding to your printer) |
| + | [* 1] This file is used only once to configure your printer to use the Bear Hemera. You can reset this configuration anytime by running the ``reset_to_prusa_mk*.gcode`` |
| + | [* 1] ``unload_filament_hemera.gcode`` |
| + | [* 1] This file is used every time you want to unload filament from your Hemera. It is needed because the filament path is much shorter than Prusa extruder. |