Changes to Step #1
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| [title] Prepare SD card | |
| - | [* 9] These instructions are only needed because no custom firmware is available yet. |
| + | [* 9] This step is only needed because no custom firmware is available yet. |
| + | [* 10] You can use latest Bear Calibration firmware or latest stock Prusa firmware. |
| [* 1] Copy the following files to your SD card | |
| [* 1] ``bear_hemera_config_mk*.gcode`` (choose the version corresponding to your printer) | |
| [* 10] This file is used only once to configure your printer to use the Bear Hemera. You can reset this configuration anytime by running the ``reset_to_prusa_mk*.gcode`` | |
| [* 1] ``unload_filament_hemera.gcode`` | |
| [* 10] You have to use this file every time you want to unload filament from your Hemera. It is needed because the filament path is much shorter than Prusa extruder. |