Changes to Step #2
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| [title] Configure the printer | |
| [* 9] This step only needed because no custom firmware is available yet. | |
| [* 1] Insert the SD card in your printer with the Bear Hemera | |
| [* 1] In the menu of your printer select "Print from SD" and choose the file ``bear_hemera_config_mk*.gcode``. | |
| + | [* 10] The printer might say it is an incomplete file but it is a wrong message, click to continue and print this file. |
| [* 10] You can now delete the ``bear_hemera_config_mk*.gcode`` file from the SD card because it will not be used anymore. |