Changes to Step #3

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Configure the printer
-[* 1] From the printer's menu, disable fan check with the menu ***Settings -> Fans check - On / Off***
- [* 10] This is useful because the Hemera fan does not have a third wire to read the fan rotation
-[* 1] From the printer's menu, disable filament sensor with the menu ***Settings -> Filament sensor - On / Off***
- [* 10] As of today, the Bear Hemera does not have filament sensor, it is then better to disable it
+[* 1] From the printer's menu, disable the fan check with the menu ***Settings -> Fans check - On / Off***
+ [* 10] This is needed because the Hemera fan does not have a third wire to read the fan rotation
+[* 1] From the printer's menu, disable the filament sensor with the menu ***Settings -> Filament sensor - On / Off***
+ [* 10] As of today, the Bear Hemera does not have filament sensor, therefore it is better to disable it