Changes to Step #5
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Testing Pinda probe |
|---|---|
| + | [* 1] Raise the Bear Hemera axis to more than 30mm by pressing the LCD knob more than 3 seconds. Turns the knob to move up. |
| + | [* 1] Place a metallic object underneath the Pinda probe. The red light on the probe should turn off. |
| + | [* 9] If the Pinda is not acting as expected verify your wiring before going further. |
| + | [* 10] Recent Prusa firmware allow you to check the value of the Pinda probe via the LCD menu ***Support -> Sensor info*** |