Changes to Step #5

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

-[title] Testing PINDA probe
-[* 1] Raise the Bear Hemera axis to more than 30mm by pressing the LCD knob more than 3 seconds. Turns the knob to move up.
-[* 1] Place a metallic object underneath the Pinda probe. The red light on the probe should turn off.
-[* 9] If this test fails, do not attempt to print or use your printer. Verify carefully the wiring of your PINDA.
-[* 10] Recent Prusa firmware allow you to check the value of the Pinda probe via the LCD menu ***Support -> Sensor info***
+[title] Testing the PINDA probe
+[* 1] Raise the X axis to more than 30mm by pressing the LCD knob for longer than 3 seconds. Turn the knob to move up
+[* 1] Place a metallic object underneath the Pinda probe. The red light on the probe should turn off
+[* 9] If this test fails, do not attempt to print or use your printer. Carefully verify the wiring of your PINDA
+[* 10] The recent Prusa firmware allows you to check the value of the Pinda probe via the LCD menu ***Support -> Sensor info***