Changes to Step #9

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Update PrusaSlicer profiles
[* 3] In PrusaSlicer, go to ***Printer Settings -> Extruder 1*** and reduce the retraction length to 0.5mm
-[* 10] The Hemera has a much shorter filament path and efficient cooling. If you use a too long retraction you might clog the Hemera. E3D recommends to use a 0.5mm retraction length as a starting point.
-[* 9] This setting might be overridden by filament settings, make sure to check those as well.
+[* 10] The Hemera has a much shorter filament path and efficient cooling. If your retraction is too long you might clog the Hemera. E3D recommends to use a 0.5mm retraction length as a starting point
+[* 9] This setting might be overridden by your filament settings, make sure to check them