Changes to Step #9
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| [title] Update PrusaSlicer profiles | |
| - | [* 3] In PrusaSlicer, go to ***Printer Settings -> Extruder 1*** and reduce the retraction length to 0.5mm |
| - | [* 10] The Hemera has a much shorter filament path and efficient cooling. If your retraction is too long you might clog the Hemera. E3D recommends to use a 0.5mm retraction length as a starting point |
| + | [* 3] In PrusaSlicer, go to ***Printer Settings -> Extruder 1*** and reduce the retraction length to 0.5mm for PETG and 0.3mm for PLA |
| + | [* 10] These values are only a starting point and you will need to adjust them later according to your tuning |
| + | [* 10] The Hemera has a much shorter filament path and efficient cooling tha original Prusa extruder. If your retraction is too long you might clog the Hemera |
| [* 9] This setting might be overridden by your filament settings, make sure to check them |