Changes to Step #11
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] First layer calibration |
|---|---|
| + | [* 1] Calibrate your first layer with the printer's menu ***Calibration -> First layer calibration***. |
| + | [* 10] The first layer calibration will remove the following message that could appears when you power on the printer: ''"Distance between tip of the nozzle and the bed surface has not been set yet. Please follow the manual, chapter First steps, section First layer calibration."''. |
| + | [* 10] After calibrating your first layer, we recommend to set your extrusion multiplier according to our guide here: [guide|8] |