5. Software configuration Step #11 History

Changes to Step #11

Edit by Grégoire Saunier — Jun 24, 2022

	[title] First layer calibration
	[* 1] Calibrate your first layer with the printer's menu *Calibration -> First layer calibration*.
	[* 10] The first layer calibration will remove the following message that could appears when you power on the printer: ''"Distance between tip of the nozzle and the bed surface has not been set yet. Please follow the manual, chapter First steps, section First layer calibration."''.
+	[* 10] It is possible that with the weight of the Hemera, the X axis is moving down on one side when the printer is off for some time. If this happens, move the X up until it crashes as explained in [guide\|31\|this step\|stepid=332]. Note that his can also happen to stock Prusa printer (and so stock Prusa extruder)
	[* 10] After calibrating your first layer, we recommend to set your extrusion multiplier according to our guide here: [guide\|8]

	[title] First layer calibration
	[* 1] Calibrate your first layer with the printer's menu *Calibration -> First layer calibration*.
	[* 10] The first layer calibration will remove the following message that could appears when you power on the printer: ''"Distance between tip of the nozzle and the bed surface has not been set yet. Please follow the manual, chapter First steps, section First layer calibration."''.
+	[* 10] It is possible that with the weight of the Hemera, the X axis is moving down on one side when the printer is off for some time. If this happens, move the X up until it crashes as explained in [guide\|31\|this step\|stepid=332]. Note that his can also happen to stock Prusa printer (and so stock Prusa extruder)
	[* 10] After calibrating your first layer, we recommend to set your extrusion multiplier according to our guide here: [guide\|8]