Changes to Step #1
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] How to insert nuts |
|---|---|
| + | [* 10] ***Inserting Hex Nuts:*** To assure that hex nuts are properly seated, do the following: |
| + | [* 2] Add a washer to the screw, to avoid damaging the printed part. |
| + | [* 5] Insert the screw through the hole on the opposite side to the hexagonal cavity. |
| + | [* 7] Thread the hex nut onto the screw and tighten the screw. |
| + | [* 9] Ensure the hex nut is aligned with the hex cavity while tightening. |
| + | [* 1] When the nut is fully seated, remove the screw being careful not to dislodge the nut. |
| + | [* 10] ***Inserting Nyloc Nuts:*** You can use the same method as used for the hex nuts. |
| + | [* 10] ***Inserting Square Nuts:*** They tend to fall out if the piece holding them is inverted. After they are inserted, check that they are properly seated by inserting a screw to engage that nut. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added