Changes to Step #1

Edit by Florian Daeubler —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] How to insert nuts
[* 10] ***Inserting Hex Nuts:*** To assure that hex nuts are properly seated, do the following:
[* 2] Add a washer to the screw, to avoid damaging the printed part.
[* 5] Insert the screw through the hole on the opposite side to the hexagonal cavity.
[* 7] Thread the hex nut onto the screw and tighten the screw.
[* 9] Ensure the hex nut is aligned with the hex cavity while tightening.
[* 1] When the nut is fully seated, remove the screw being careful not to dislodge the nut.
[* 10] ***Inserting Nyloc Nuts:*** You can use the same method as used for the hex nuts.
-[* 10] ***Inserting Square Nuts:*** They tend to fall out if the piece holding them is inverted. After they are inserted, check that they are properly seated by inserting a screw to engage that nut.
+[* 10] ***Inserting Square Nuts:*** They tend to fall out of the piece holding them is inverted. After they are inserted, check that they are properly seated by inserting a screw to engage the nut.