Changes to Step #4
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Extruder motor |
|---|---|
| + | [* 7] Locate the extruder motor so the wires face to the left. Rotate the shaft so that the flat is facing up. |
| + | [* 5] Mount the Bondtech pulley on the extruder motor shaft so that the geared portion is furthest from the motor body and with the set screw contacting the flat portion of the shaft. |
| + | [* 2] The motor shaft should protrude from the pulley by approximately 1mm. |
| + | [* 1] Secure the set screw to avoid the gear moving. We will fine tune the position later. |
| + | [* 4] Verify the orientation of the motor cables. |
| + | [* 3] Secure the extruder motor to the ''extruder_body'' using two M3x25 screws. |
| + | [* 6] Verify the motor cables orientation |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added