Changes to Step #6
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] X carriage assembly |
|---|---|
| + | [* 3] Verify that the M3x25mm screws are snug |
| + | [* 2] Slide an M3 square nut into the extruder_body. |
| + | [* 7] Using an M3x10 screw attach the ''extruder_body'' to the ''x_carriage''. |
| + | [* 5] Using an M3x40 screw with an M3 washer attach the ''extruder_body'' to the ''x_carriage''. |
| + | [* 9] Verify that ''extruder_body'' and ''x_carriage'' are correctly aligned. Adjust if necessary with the M3x10 and M3x40 screws |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added