Changes to Step #6

Edit by Florian Daeubler —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] X carriage assembly
[* 3] Verify that the M3x25mm screws are snug
-[* 2] Slide an M3 square nut into the extruder_body.
-[* 7] Using an M3x10 screw attach the ''extruder_body'' to the ''x_carriage''.
-[* 5] Using an M3x40 screw with an M3 washer attach the ''extruder_body'' to the ''x_carriage''.
-[* 9] Verify that ''extruder_body'' and ''x_carriage'' are correctly aligned. Adjust if necessary with the M3x10 and M3x40 screws
+[* 2] Slide a M3 square nut into the extruder_body.
+[* 7] Use a M3x10 screw to attach the ''extruder_body'' to the ''x_carriage''.
+[* 5] Use a M3x40 screw with a M3 washer to attach the ''extruder_body'' to the ''x_carriage''.
+[* 9] Verify that ''extruder_body'' and ''x_carriage'' are correctly aligned. Use the M3x10 and M3x40 screws to adjust, if necessary.