Changes to Step #7
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Filament sensor assembly |
|---|---|
| + | [* 9] Verify that the ''filament_sensor_lever'' and the filament sensor pocket on top of the ''extruder_body'' does not have strings and are well printed. Clean up if necessary. |
| + | [* 3] Insert the longer magnet (20x6x2mm) inside the ''filament_sensor_lever''. |
| + | [* 6] Place the smaller magnet (10x6x2mm) so that it is attracted to the ''filament_sensor_lever''. The smaller magnet should be on the flat side of the lever. |
| + | [* 4] Remove the smaller magnet from the ''filament_sensor_lever'', taking care to keep the orientation the same. Insert the smaller magnet with the same orientation into the ''extruder_body''. ***DO NOT*** insert the ''filament_sensor_lever'' yet. |
| + | [* 9] Verify that the smaller magnet is fully pressed into its cavity. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added