Changes to Step #9

Edit by Florian Daeubler —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Filament sensor assembly
[* 9] In order to avoid electrostatic discharge to the filament sensor, touch something metallic that is linked to the ground. Like pipework or a faucet.
-[* 3] Carefully secure the Prusa IR sensor with an M2x8 screw. Do not over tighten.
+[* 3] Carefully secure the Prusa IR sensor with a M2x8 screw. Do not over-tighten.
[* 6] Adjust the Prusa IR sensor to make sure that it is parallel to the border of the pocket. Finish tightening the screw; it only needs to be tightened sufficiently to hold the sensor in place