Changes to Step #12

Edit by Florian Daeubler —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Extruder idler preparation
-[* 3] Locate the Bondtech drive gear. This is the one that has NO set screw.
+[* 3] Locate the Bondtech drive gear. It is the one that has NO set screw.
[* 6] Lubricate the needle bearings with a dab of lithium based grease
[* 5] Slide the two Bondtech needle bearings into the Bondtech drive gear.