Changes to Step #13
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Extruder idler preparation |
|---|---|
| + | [* 3] Place the idler gear into the ''extruder_idler''. Note the orientation of the teeth. |
| + | [* 9] Make sure that both needle bearings are still present in the idler gear. |
| + | [* 5] Insert the shaft from the direction shown in the diagram. Fully insert the shaft, it should be flush with the printed part, else the the idler will not close properly. |
| + | [* 7] Insert a square nut in the lateral pocket. |
| + | [* 9] Double check the orientation of the gears. |
| + | [* 9] Double check that no needle bearing has fallen out during these steps. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added