Changes to Step #13

Edit by Florian Daeubler —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Extruder idler preparation
[* 3] Place the idler gear into the ''extruder_idler''. Note the orientation of the teeth.
-[* 9] Make sure that both needle bearings are still present in the idler gear.
-[* 5] Insert the shaft from the direction shown in the diagram. Fully insert the shaft, it should be flush with the printed part, else the the idler will not close properly.
+[* 9] Make sure that both needle bearings are still inserted in the idler gear.
+[* 5] Insert the shaft from the direction shown in the diagram. Fully insert the shaft, it should be flush with the printed part or the the idler will not close properly.
[* 7] Insert a square nut in the lateral pocket.
[* 9] Double check the orientation of the gears.
[* 9] Double check that no needle bearing has fallen out during these steps.