Changes to Step #14
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Extruder idler assembly |
|---|---|
| + | [* 5] Slide an M3 washer on an M3x40 screw. |
| + | [* 3] Insert the screw into the top, left, hole of the ''x_carriage'', until it protrudes just enough for you to place an M3 washer on it. |
| + | [* 4] Carefully place an M3 washer on the end of the screw. |
| + | [* 7] Carefully slide the ''extruder_idler'' into the opening, taking care not to displace the M3 washer and insert the screw to act as the hinge for the idler door.. |
| + | [* 8] Gently tighten the screw into the extruder motor, the ''extruder_idler'' must rotate freely. |
Image 1
No previous image
Added
Image 2
No previous image
Added