Changes to Step #14

Edit by Florian Daeubler —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Extruder idler assembly
-[* 5] Slide an M3 washer on an M3x40 screw.
-[* 3] Insert the screw into the top, left, hole of the ''x_carriage'', until it protrudes just enough for you to place an M3 washer on it.
-[* 4] Carefully place an M3 washer on the end of the screw.
-[* 7] Carefully slide the ''extruder_idler'' into the opening, taking care not to displace the M3 washer and insert the screw to act as the hinge for the idler door..
+[* 5] Slide a M3 washer on a M3x40 screw.
+[* 3] Insert the screw into the top, left hole of the ''x_carriage'', until it protrudes just enough for you to place a M3 washer on it.
+[* 4] Carefully place a M3 washer on the end of the screw.
+[* 7] Carefully slide the ''extruder_idler'' into the opening, taking care not to displace the M3 washer and insert the screw to act as the hinge for the idler door.
[* 8] Gently tighten the screw into the extruder motor, the ''extruder_idler'' must rotate freely.