Changes to Step #15
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Prepare the PTFE tube |
|---|---|
| + | [* 9] The Bear extruder uses a PTFE tube length of 50mm. It is the same PTFE tube than MK2S, MK2.5 (non-S) and MK3 (non-S). The original Prusa MK2.5S or MK3S extruder is using a PTFE tube length of 44.2mm which will be too short for the Bear extruder. |
| + | [* 1] You should have prepared the PTFE tube during guide [guide|16|stepid=242]. Make sure you have followed those steps. |
Image 1
No previous image
Added