Changes to Step #16
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Hotend assembly |
|---|---|
| + | [* 10] Hotend wires are not visible on these images. Use the heatblock to orientate the hotend correctly. |
| + | [* 9] Make sure your PTFE tube length is 50mm. |
| + | [* 3] Push the collet (black plastic part) down and fully insert the PTFE tube. Whilst pressing the PTFE into the hotend, lift the collet upwards, to lock the PTFE tube in place |
| + | [* 6] Insert the ''hotend_collet_clip''. This prevents the collet from loosening and keeps the PTFE tube locked in place. |
| + | [* 5] Insert the hot end into the ''extruder_body'' so that the heater and thermistor wires are properly oriented. |
| + | [* 2] Note the position of the heater and thermistor wires. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added