Changes to Step #16

Edit by Florian Daeubler —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Hotend assembly
[* 10] Hotend wires are not visible on these images. Use the heatblock to orientate the hotend correctly.
-[* 9] Make sure your PTFE tube length is 50mm.
-[* 3] Push the collet (black plastic part) down and fully insert the PTFE tube. Whilst pressing the PTFE into the hotend, lift the collet upwards, to lock the PTFE tube in place
+[* 9] Verify your PTFE tube is 50mm long.
+[* 3] Push the collet (black plastic part) down and fully insert the PTFE tube. Whilst pressing the PTFE tube into the hotend, lift the collet upwards, to lock the PTFE tube in place
[* 6] Insert the ''hotend_collet_clip''. This prevents the collet from loosening and keeps the PTFE tube locked in place.
-[* 5] Insert the hot end into the ''extruder_body'' so that the heater and thermistor wires are properly oriented.
+[* 5] Insert the hot end into the ''extruder_body'' with correct orientation of the heater and thermistor wires.
[* 2] Note the position of the heater and thermistor wires.