Changes to Step #17

Edit by Florian Daeubler —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Extruder cover assembly
[* 2] Insert one M3 square nut
[* 5] Insert one M3 hex nut
[* 4] Insert one M3 hex nut
-[* 6] Insert two M3x40 screw to lock the hotend in place
-[* 9] Check that the hotend has not rotated, is perpendicular to the extruder body and is correctly oriented. Adjust if necessary.
+[* 6] Insert two M3x40 screws and tighten them alternately to lock the hotend in place
+[* 9] Check that the hotend has not rotated, is perpendicular to the extruder body and is correctly orientated. Adjust if necessary.