Changes to Step #17
Edit by Matthew Van Zante —
Edit declined by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| [title] Extruder cover assembly | |
| [* 2] Insert one M3 square nut | |
| [* 5] Insert one M3 hex nut | |
| - | [* 4] Insert one M3 hex nut |
| + | [* 4] Insert one M3 nylock hex nut |
| [* 6] Insert two M3x40 screws and tighten them alternately to lock the hotend in place | |
| [* 9] Check that the hotend has not rotated, is perpendicular to the extruder body and is correctly oriented. Adjust if necessary. |