Changes to Step #18
Edit by Florian Daeubler —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| [title] Hotend fan assembly | |
| [* 2] Carefully route the motor wires as shown in the figure. | |
| [* 4] Verify that the wires sit correctly in the channel. | |
| [* 7] This surface will be touching the ''extruder_body''. It is the side with the manufacturers label on it. The wires come out from this side and the fan should be oriented so that they point towards the rear of the extruder. | |
| - | [* 5] Carefully route the hotend fan wires in the ''x_carriage''. |
| + | [* 5] Carefully route the hotend fan wires in the channel of the ''x_carriage''. |
| [* 3] Attach the hotend fan with four screws. Follow the screw type according to your hotend fan: | |
| - | [* 3] Sunon & Delta : M3x16 button head |
| - | [* 3] Noctua : M3x14 socket head |
| + | [* 3] Sunon & Delta : M3x16 button head screws |
| + | [* 3] Noctua : M3x14 socket head screws |
| [* 9] Check that no wires are pinched. Check the orientation of the hotend fan, the air should be blowing over the hotend heatsink. On the edge of the fan body, there are usually two arrows, indicating the direction of rotation and direction of flow. Ensure that the arrow indicating flow is pointing in towards the hotend. |