Changes to Step #19

Edit by Florian Daeubler —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Bondtech gear alignment
[* 7] Open the ''extruder_idler''
[* 5] Insert a piece of 1.75 mm filament through the ''extruder_body'' into the PFTE tube.
-[* 4] Using the Bondtech set screw, carefully center the filament on the drive teeth.
+[* 4] Center the filament on the drive teeth carefully, using the Bondtech set screw.
[* 4] Tighten the set screw. Don't tighten too much as you will damage the thread.
[* 1] Remove the filament.
-[* 8] This is a good time to put a dab of lithium based grease on the gears. Make sure that you do not get any grease on the drive teeth.
+[* 8] This is a good time to put a dab of lithium based grease on the gears. Make sure that you do not put any grease on the drive teeth.