Changes to Step #20
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Extruder idler tensioner screw |
|---|---|
| + | [* 1] Make sure that you have completely removed the filament from the ''extruder_body''. |
| + | [* 1] Slide an extruder spring onto an M3x40 screw. |
| + | [* 1] Close the ''extruder_idler'' door. |
| + | [* 3] Slide the screw with the extruder spring into the ''extruder_body''. |
| + | [* 3] Tighten the screw into the ''extruder_idler'' until the head is flush with the surface of the body. |
| + | [* 10] If you have trouble closing the ''extruder_idler'', try rotating the Bondtech idler gear, with a finger, to ensure that the gears are meshed. |
Image 1
No previous image
Added
Image 2
No previous image
Added