Changes to Step #20

Edit by Florian Daeubler —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Extruder idler tensioner screw
[* 1] Make sure that you have completely removed the filament from the ''extruder_body''.
-[* 1] Slide an extruder spring onto an M3x40 screw.
+[* 1] Slide an extruder spring onto a M3x40 screw.
[* 1] Close the ''extruder_idler'' door.
[* 3] Slide the screw with the extruder spring into the ''extruder_body''.
[* 3] Tighten the screw into the ''extruder_idler'' until the head is flush with the surface of the body.
[* 10] If you have trouble closing the ''extruder_idler'', try rotating the Bondtech idler gear, with a finger, to ensure that the gears are meshed.