Changes to Step #21

Edit by Florian Daeubler —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

-[* 5] Slide an M3 washer on an M3x18 screw. Do the same for another M3x18 screw.
-[* 2] Attach the print fan using the screws
-[* 9] Be careful not to over tighten to avoid damaging the fan.
+[* 5] Slide a M3 washer on a M3x18 screw. Do the same for another M3x18 screw.
+[* 2] Attach the print fan using the M3x18 screws
+[* 9] Be careful not to over-tighten the screws to avoid damaging the fan.