Changes to Step #22

Edit by Florian Daeubler —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] PINDA probe assembly
[* 4] Place a square nut in the ''extruder_body'' for the ''pinda_mount''.
-[* 8] Slide an M3x10 screw into the ''pinda_mount'' and engage the square nut, but do not tighten yet.
+[* 8] Slide a M3x10 screw into the ''pinda_mount'' and engage the square nut, but do not tighten yet.
[* 5] Insert the PINDA into the mount so that the sensor end is approximately 12mm below the bottom of the ''pinda_mount''. Tighten the screw just enough to keep the PINDA from falling out. The optimum PINDA position will be adjusted later.
-[* 2] Route the PINDA wires
-[* 7] Route the print fan wires
-[* 3] Secure the cables with a zip tie. Be sure to leave some slack since the PINDA position will need to be adjusted later.
+[* 2] Route the PINDA wires as indicated
+[* 7] Route the print fan wires as indicated
+[* 3] Secure the wires with a zip tie. Be sure to leave some slack since the PINDA position will need to be adjusted later.
[* 6] This is the peferred example of how the PINDA and print fan cables should be wired.