Changes to Step #2

Edit by Florian Daeubler —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Extruder attachment
[* 7] Clamp the extruder on the top and bottom linear bearings of the X axis
-[* 2] Make sure all cables, except the hotend cables, are running on top of the bottom smooth rod (between two X smooth rods). The hotend cable should stay under the bottom smooth rod.
-[* 4] Clamp the top of the ''x_carriage_back''
-[* 5] Secure it with two M3x10 screws in top holes. Don't tighten them right now!
-[* 3] Finish securing it with two M3x18 screws in bottom holes. Don't tighten them right now
-[* 6] Alternatively tighten the four screws while moving the extruder. Don't over tighten them.
+[* 2] Make sure all cables, except the hotend cables, are running on top of the bottom smooth rod (between two X smooth rods). The hotend cables should stay under the bottom smooth rod.
+[* 4] Clamp the top of the ''x_carriage_back''.
+[* 5] Secure it with two M3x10 screws in the top holes. Don't tighten them yet!
+[* 3] Finish securing it with two M3x18 screws in the bottom holes. Don't tighten them yet!
+[* 6] Alternatively tighten the four screws while moving the extruder. Don't over-tighten them.