Changes to Step #2

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Extruder attachment
[* 7] Clamp the extruder on the top and bottom linear bearings of the X axis
[* 9] Make sure to not let fall down the extruder until it is secured, keep an hand on it.
[* 2] Make sure all cables, except the hotend cables, are running on top of the bottom smooth rod (between two X smooth rods). The hotend cables should stay under the bottom smooth rod.
[* 4] Clamp the top of the ''x_carriage_back''.
[* 5] Secure it with two M3x10 screws in the top holes. Don't tighten them yet!
[* 3] Finish securing it with two M3x18 screws in the bottom holes. Don't tighten them yet!
-[* 6] Alternatively tighten the four screws while moving the extruder. Don't over-tighten them.
+[* 6] Alternately tighten the four screws while moving the extruder. Don't over-tighten them.