Changes to Step #3
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Prepare belt routing |
|---|---|
| + | [* 4] Adjust the two ''x_end_idler'' screws so that the ''x_end_idler_tensioner'' is flush with the ''x_end_idler'', as shown in the first image. |
| + | [* 9] Verify that the ''x_end_idler_tensioner'' is not recessed into, or proud of, the ''x_end_idler''. It should ***not*** look like the second or third image. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added