Changes to Step #3

Edit by Florian Daeubler —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Prepare belt routing
[* 4] Adjust the two ''x_end_idler'' screws so that the ''x_end_idler_tensioner'' is flush with the ''x_end_idler'', as shown in the first image.
-[* 9] Verify that the ''x_end_idler_tensioner'' is not recessed into, or proud of, the ''x_end_idler''. It should ***not*** look like the second or third image.
+[* 9] Verify that the ''x_end_idler_tensioner'' is not recessed into, or protruding out of, the ''x_end_idler''. It should ***not*** look like the second or third image.