Changes to Step #4

Edit by Florian Daeubler —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Attach the X belt
[* 3] Slide one end of the 2GT drive belt into the right side of the ''x_carriage''.
-[* 10] If you have trouble inserting the belt, it might be due to a good enough extrusion multiplier issue or to the use of a non-genuine or non-2GT belt.
-[* 9] Verify that the belt is fully inserted into the slot and that it extends into the central space.
+[* 10] If you have trouble inserting the belt, it might be due to an extrusion multiplier issue (over-extrusion) or due to the use of a non-genuine or non-2GT belt.
+[* 9] Verify that the belt is fully inserted into the slot and that it extends into the enlarged center space.
[* 6] Route the drive belt through the ''x_end_motor'', around the drive pulley and back out through the ''x_end_motor''.