Changes to Step #4
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| [title] Attach the X belt | |
| [* 3] Slide one end of the 2GT drive belt into the right side of the ''x_carriage''. | |
| - | [* 10] If you have trouble inserting the belt, it might be due to an extrusion multiplier issue (over-extrusion) or due to the use of a non-genuine or non-2GT belt. |
| + | [* 10] If you have trouble inserting the belt, it might be due to an extrusion multiplier issue (over-extrusion) or due to the use of a non-genuine or non-2GT belt. Check the [guide|34|step 6 of Preflight check and disassembly|stepid=663] chapter for more details. |
| [* 9] Verify that the belt is fully inserted into the slot and that it extends into the enlarged center space. | |
| [* 6] Route the drive belt through the ''x_end_motor'', around the drive pulley and back out through the ''x_end_motor''. |