Changes to Step #5
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| [title] Attach the X belt | |
| [* 7] Route the drive belt through the x_carriage. | |
| [* 5] Continue to route the drive belt around the idler of the ''x_end_idler_tensioner'' and go back in the direction of the ''x_carriage''. | |
| + | [* 10] If you have difficulties to pass the belt around the idler you can tape the belt end with the end of a zip tie. Then, feed the zip tie into the idler. |
| [* 3] To finish routing the drive belt, partially insert the belt into the ''x_carriage'' | |
| [* 10] The belt should have almost no tension, it will be adjusted later. | |
| [* 6] Trim the belt to length, leaving a few teeth to extend into the central space. Finish by fully inserting the belt into the ''x_carriage'' | |
| [* 9] Verify that the belt is fully inserted into the slot and that it extends into the central space. You can use tweezers or a small screwdriver to ensure that the belt is pushed fully into the slot. | |
| [* 9] Verify that no cable is pinched by the belt. |