Changes to Step #5

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Attach the X belt
-[* 7] Route the drive belt through the x_carriage.
-[* 5] Continue to route the drive belt around the idler of the ''x_end_idler_tensioner'' and go back in the direction of the ''x_carriage''.
-[* 10] If you have difficulties to pass the belt around the idler you can tape the belt end with the end of a zip tie. Then, feed the zip tie into the idler.
-[* 3] To finish routing the drive belt, partially insert the belt into the ''x_carriage''
-[* 10] The belt should have almost no tension, it will be adjusted later.
+[* 7] Route the belt through the x_carriage.
+[* 5] Continue to route the belt around the idler of the ''x_end_idler_tensioner'' and go back in the direction of the ''x_carriage''.
+ [* 10] If you have difficulties to pass the belt around the idler you can tape the belt end with the end of a zip tie. Then, feed the zip tie into the idler.
+[* 3] To finish routing the belt, partially insert the belt into the ''x_carriage''
+ [* 10] The belt should have almost no tension, it will be adjusted later.
[* 6] Trim the belt to length, leaving a few teeth to extend into the center space. Finish by fully inserting the belt into the ''x_carriage''
[* 9] Verify that the belt is fully inserted into the slot and that it extends into the enlarged center space. You can use tweezers or a small screwdriver to ensure that the belt is pushed fully into the slot.
[* 9] Verify that no cable is pinched by the belt.