Changes to Step #8
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Filament sensor cable |
|---|---|
| + | [* 2] Plug the filament sensor cables into the filament sensor connector. The red wire of the cable should be on the left (on the PSU side), when connected to the filament sensor. |
| + | [* 2] Route the filament sensor cable through the channel in the ''x_carriage_back''. |
| + | [* 9] Create a small loop of cables close to the filament sensor connector. This is to reduce potential stress on the cable, caused by movement of the extruder. |
Image 1
No previous image
Added
Image 2
No previous image
Added