Changes to Step #9
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Extruder cables |
|---|---|
| + | [* 10] If you do not have the textile sleeve, these instructions apply to the plastic spiral wrap as well. |
| + | [* 10] The textile sleeve should be 13mm outside diameter and 490mm long. |
| + | [* 6] Insert the 3 mm nylon filament into the end of the ''cable_guide_back''. |
| + | [* 6] The nylon filament should slide in at least 10 mm. If you have trouble inserting it, the nylon filament end may be tapered. by a diagonal cut and/or needle nose pliers may be used to get a better grip.. |
| + | [* 8] Wrap a few centimetres of the textile sleeve around all of the cables coming out of the ''x_carriage_back''. Do not wrap the nylon or hotend cables. |
| + | [* 5] Slide the textile wrap up to the ''x_carriage_back'' and make it as tight as possible around the cables. |
| + | [* 3] Insert two zip ties, through the bottom of the cable guide and use then to secure the hotend cables. Take care to position the zip ties as shown. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added