Changes to Step #9

Edit by Florian Daeubler —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Extruder cables
[* 10] If you do not have the textile sleeve, these instructions apply to the plastic spiral wrap as well.
[* 10] The 3mm nylon filament can also be a piece of 2.85mm nylon filament for 3D printers.
[* 10] The textile sleeve should be 13mm outside diameter and 490mm long.
-[* 6] Insert the 3 mm nylon filament into the end of the ''cable_guide_back''.
-[* 6] The nylon filament should slide in at least 10 mm. If you have trouble inserting it, the nylon filament end may be tapered. by a diagonal cut and/or needle nose pliers may be used to get a better grip..
+[* 6] Insert the 3mm nylon filament into the end of the ''cable_guide_back''.
+[* 6] The nylon filament should slide in at least 10 mm. If you have trouble inserting it, the nylon filament end may need to be tapered with a diagonal cut and/or needle nose pliers may need to be used to get a better grip.
[* 8] Wrap a few centimetres of the textile sleeve around all of the cables coming out of the ''x_carriage_back''. Do not wrap the nylon or hotend cables.
[* 5] Slide the textile wrap up to the ''x_carriage_back'' and make it as tight as possible around the cables.
-[* 3] Insert two zip ties, through the bottom of the cable guide and use then to secure the hotend cables. Take care to position the zip ties as shown.
+[* 3] Insert two zip ties, through the bottom of the cable guide and use them to secure the hotend cables. Take care to position the zip ties as shown.