Changes to Step #1

Edit by Florian Daeubler —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Pinda adjustment
[* 9] Ensure the hotend has cooled down and turn off the printer.
-[* 6] Place a sheet of paper on your heated bed. Remove any residual filament coming out of the nozzle.
+[* 6] Place a sheet of paper on your heated bed. Remove any residual filament from the nozzle.
[* 2] Center your extruder on the X axis. Move it down by rotating both the Z lead screws at the same time. Move the extruder down until the nozzle is just touching the paper.
[* 4] Stop when the nozzle is just touching the paper.
[* 7] Place the middle section of a zip tie under the Pinda.
[* 5] Loosen the M3x10 screw and gently move the PINDA down until it is touching the zip tie.
[* 5] Tighten the M3x10 screw to secure the PINDA in place.